Filter
Top Products
System Management: Vendor Commands
10007175-02 KAT4000 User’s Manual
9-19
Set Handle Switch Command
The Set Handle Switch command sets the state of the Hot Swap handle switch in (Manual)
Standalone mode.
Table 9-15: Set Handle Switch Command
Get Payload Communication Time-Out Command
The Get Payload Communication Time-Out command reads the payload communication
time-out value.
Table 9-16: Get Payload Communication Time-Out Command
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4 Handle Switch Status
0x00 The handle switch is open
0x01 The handle switch is closed
0x02 The handle switch state is read from hardware
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5Payload Time-out
Payload communication time-out measured in hundreds of
milliseconds. Thus, the payload communication time-out
may vary from 0.1 to 25.5 seconds.