Filter
Top Products
Epson Research and Development
Page 5
Vancouver Design Center
13505PWR Software Suspend Power Sequencing Utility S1D13505
Issue Date: 01/02/02 X23A-B-007-03
Comments
• The
/i
argument is to be used when the registers have not been previously initialized.
• When using a PC with the S5U13505 evaluation board, the PC must not have more than 12M
bytes of system memory.
• GPIO1 is used to signal when the software suspend mode, hardware suspend mode, or LCD has
been enabled or disabled.
• Hardware suspend is changed by reading or writing to a memory address decoded by the PAL on
the S5U13505 evaluation board. This PAL is currently only used for PC platforms, so the
S5U13505 evaluation board does not support hardware suspend on embedded platforms.
Program Messages
ERROR: Did not detect S1D13505.
The HAL was unable to read the revision code register on the S1D13505. Ensure that the S1D13505
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument
/softwar
e
was selected more than once. Select
/software
only once.
ERROR: Already selected HARDWARE.
Command line argument
/hardware
was selected more than once. Select
/hardware
only once.
ERROR: Already selected LCD.
Command line argument
/lcd
was selected more than once. Select
/lcd
only once.
ERROR: Already selected ENABLE.
Command line argument
/enable
was selected more than once. Select
/enable
only once.
ERROR: Already selected DISABLE.
Command line argument
/disable
was selected more than once. Select
/disable
only once.
ERROR: Select /software, /hardware or /lcd.
Did not select one of the following command line arguments:
/software, /hardware
or
/lcd
.
Select
/software
,
/hardware
or
/lcd.
ERROR: Select /enable or /disable.
Neither command line argument
/enable
or
/disable
was selected. Select
/enable
or
/disable
.