Filter
Top Products
Chapter 16-Network Services
Polycom, Inc. 16-57
— Modify the Management Network parameters on the USB Key. For more details see
the RMX™ 1800 Getting Started Guide, "Modifying the Factory Default Management
Network Settings on the USB Key” on page 2-6.
2 Hardware Installation and Setup
— Mount the Collaboration Server in a rack. For more details see the RMX™ 1800
Getting Started Guide Getting Started Guide, "Hardware Installation and Setup” on
page 2-6.
— Connect the necessary cables. For details, see RMX™ 1800 Getting Started Guide
Getting Started Guide, "Hardware Installation and Setup” on page 2-6.
3 First Entry Power-up and Configuration
— Power up the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 1: First-time Power-up” on page 2-27.
— Register the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 2: Product Registration” on page 2-28.
— Connect to the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 3: Connection to MCU” on page 2-29.
— Configure the Default IP Network Service using the information for one of the
networks connected a media card installed in the system. For more details see the
RMX™ 1800 Getting Started Guide Getting Started Guide, "Procedure 4: Modifying the
Default IP Service and ISDN/PSTN Network Service Settings” on page 2-31.
— Optional. Configure the ISDN/PSTN Network Service. For more details see the
RMX™ 1800 Getting Started Guide Getting Started Guide, "ISDN/PSTN Services” on
page 2-4.
4 Modify the required System Flag to enable Multiple Services and reset the MCU.
5 Add the required IP Network Services to accommodate the networks connected to the
Collaboration Server.
6 Select a Network Service to act as default for dial out and gateway calls for which the
Network Service was not selected.
7 Place several calls and run conferences to ensure that the system is configured
correctly."Gath
er Network Equipmen
t and Address Information - IP Network Services
Required Information” on page 16-40.
Upgrading to Multiple Services
1 Gather Network Equipment and Address Information for each of the networks that will
be connected to the Collaboration Server unit. For a list of required address, see RMX™
1800 Getting Started Guide, "Gather Network Equipment and Address Information” on
page 2-2.
2 Upgrade to the new version and install the activation key that contains the Multiple
Services license as described in the RealPresence Collaboration Server (RMX) 1500/2000/
4000 Release Notes
3 Place several calls and run conferences to ensure that the system upgrade was
completed successfully.
4 Modify the required System Flag to enable Multiple Services, DO NOT reset the MCU
yet.