Filter
Top Products
Chapter 24-Collaboration Server Hardware Monitoring
Polycom, Inc. 24-31
Figure 24-4 RealPresence Collaboration Server (RMX) 1500 Diagnostics Tests & Monitoring
Tests
5 When the Collaboration Server enters “Diagnostics Mode”, the status MPM+/MPMx,
CNTL/CNTL 1500/CNTL 4000 and RTM IP/RTM IP 1500/RTM IP 4000 changes to
“Diagnostics”.
You can run “Diagnostics” tests on a MPM+/MPMx card by double clicking any one of
the hardware components indicating “Diagnostics” in the status column.
Figure 24-5 RealPresence Collaboration Server (RMX) 2000/4000 MPMx D - DSP DSP Sub Test
selection
6 Select the Run all Tests box and then click Run Selected Tests.
Run all Test
Selection
Diagnostics Test Monitoring
Run a “Diagnostics” test on a CTNL card by clicking the CTNL hardware component that indicates
“Diagnostics” in the status column.
Optional. In the Diagnostics - Active Test box you can select specific tests to run and then click Run
Selected Tests.
Table 24-20 Tests Selection - Additional Test Parameters
Parameter Description
Loop Test Enter the amount of times the test is to repeat itself in succession.
Stop On Failure Stops tests upon a failure.