Filter
Top Products
Chapter 23 - Ultra Secure Mode
Polycom, Inc. 23-47
4 Select the Enable Whitelist check box.
All IP addresses in the list are displayed and the Add and Remove buttons become
active.
5 Modify the White List.
Both IPv4 and IPv6 addresses are supported and the system will only allow an entry of
the type of IP addresses for which the Management Network Service is configured
according to Table 23-14.
— If the system changes its IP addressing mode (e.g. from IPv4 only to both IPv4 &6)
while the White List is enabled, the White List is disabled and a message, White list
has been disabled please reconfigure, is displayed.
— IPv4 addresses can be added as a range by using the wildcard character, *, to
substitute the 3rd and 4th dotted decimal numbers of the IP address, e.g. 11.10.*.*
Table 23-14 IP Address Modes
IP Address Modes
RMX Workstation / Device
IPv4
IPv4
IPv4 & IPv6
IPv6
IPv6
IPv4 & IPv6
IPv4 & IPv6
IPv4
IPv6
IPv4 & IPv6