Filter
Top Products
102 CHAPTER 7: POS TERMINAL ACCESS SERVICE
9 Configure POS access interface FCM2
[Router] interface fcm2
[Router-FCM2] async mode pos 3
Configuration Example when the Router is Located at the FEP Side in
Asynchronous Connection Mode
I. Networking Requirements
Three POS terminals access the Router A located at the FEP side through the FCM
and connect to UNIX A (10.1.1.1) and UNIX B (11.1.1.1) in asynchronous
connection mode.
II. Networking Diagram
Figure 43 Networking diagram when the router is located at the FEP side in asynchronous
connection mode
III. Configuration Procedure
1 Start the POS access server.
[Router] pos-server enable
2 Configure the POS application to UNIX A in asynchronous connection mode, the
connected interface is async 0, the application sequence number is 0.
[Router] pos-server app flow 0 async 0
3 Configure the POS application to UNIX B in asynchronous connection mode, the
connected interface is async 1, the application sequence number is 1.
[Router] pos-server app flow 1 async 1
4 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f1 to application 0).
[Router] pos-server map 01f1 0
5 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f2 to application 1).
[Router] pos-server map 01f2 1
6 Configure POS access interface FCM0.
[Router] interface fcm0
[Router-FCM0] async mode pos 1
7 Configure POS access interface FCM1.
[Router] interface fcm1
[Router-FCM1] async mode pos 2
8 Configure POS access interface FCM2.
[Router] interface fcm2
PSTN
11.1.1.1/24
10.1.1.1/24
A0
A1
FCM
POS
terminal
11.1.1.2/24
Quidway
POS
terminal
POS
terminal
11.1.1.1/24
UNIX B
UNIX A
Router