Filter
Top Products
366 CHAPTER 23: CONFIGURING IP COUNT
Figure 134 Networking for an IP Count application
IP Count mainly implements the following functions:
■ Configure IP Count list
■ Make statistics on the output and input packets
■ Make statistics on the packets processed by the firewall
■ Display all packet statistics
■ Clear all packet statistics
IP Count
Configuration
Basic Configuration includes:
■ Enable IP Count Service
■ Enable IP Count on an interface
Advanced Configuration includes:
■ Configure IP Count list
■ Configure upper threshold for accounting entries in Interior-List
■ Configure upper threshold for accounting entries in Exterior-List
■ Configure timeout time of IP Count statistics list entries
1 Enable IP Count Service
This command can be used to enable or disable IP Count service. You can
configure IP Count to make statistics on the packets that the router has input or
output depending on the specific requirements on the router.
Perform the following configuration in system view.
Table 399 Enable/Disable IP Count service
By default, IP Count is not enabled.
2 Configure IP Count on an Interface
PC1
A
PC2
PC3
B
PC4
E0:
169.254.10.1
E1
Router
169.254.10.1
Operation Command
Enable IP Count ip count enable
Disable IP Count undo ip count enable