Filter
Top Products
Configure Frame Relay 255
will not take effect. On the MFR interface, you can configure the network layer
parameters (e.g., IP address) and Frame Relay parameters (e.g., DLCI). The physical
interface bundled on the MFR interface will use the parameters on the MFR
interface.
Configure MFR
The configuration tasks of the MFR are listed as follows:
■ Configure a MFR Bundle
■ Configure a MFR Bundle Link
1 Configure a MFR bundle
Please perform the following configuration in system view.
Table 291 Configure a MFR bundle interface (MFR interface)
By default, no MFR bundle interface is configured.
Please perform the following configuration in MFR interface view.
Table 292 Configure MFR interface parameter
The default bundle identification s “mfr” plus the bundle number, for example,
“mfr1.
By default, the maximum number of the fragments allowed by the MFR interface
is the same with the number of the physical interfaces bundled to it.
By default, the voice packets are sent on the multiple physical interfaces bundled
to the MFR interface by turns.
2 Configure a MFR bundle link
Please perform the following configuration in synchronous serial interface view.
Table 293 Configure physical interface's link layer protocol to Multilink Frame Relay
By default, no MFR bundle link is created. To remove the association between the
physical interface and the MFR interface, configure the interface's link layer
protocol to a none MFR type using the
link-protocol command.
Please perform the following configuration in synchronous serial interface view.
Operation Command
Configure or enter a MFR bundle interface interface mfr number [
.subnumber ] [ multipoint |
point-to-point ]
Remove a MFR bundle interface undo interface mfr number [
.subnumber ]
Operation Command
configure bundle identification mfr bundle-name name
Restore the default bundle identification undo mfr bundle-name
Set the maximum number of the fragments
allowed by the MFR interface.
mfr window-size number
Operation Command
Configure physical interface's link layer protocol to
Multilink Frame Relay and associate the link with a
bundle.
link-protocol fr mfr number [
name ]