Filter
Top Products
40 CHAPTER 3: SYSTEM MANAGEMENT
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [N] y
This board's LAN IP address? [169.254.1.1] 10.110.10.1
Subnet mask for LAN (0 for none)? [255.255.0.0]
TFTP SERVER PARAMETERS:
IP address of the TFTP server? [169.254.75.166] 10.110.10.13
What is the name of the file to be loaded and started? [m8240ram.arj]
How long (in seconds) should CPU delay before starting up? [5]
The IP address of the TFTP server? [169.254.75.166] must be set to the IP
address of the PC connected to the Ethernet port of the router. After the last
parameter is set the following prompts will appear to ask for confirmation:
-------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 10.110.10.1
LAN interface's subnet mask is 0xffff0000
HARDWARE PARAMETERS:
Processor type is MPC8240
Internal Clock Rate 250 Mhz
External Clock Rate 100 Mhz
LAN Controller is DEC 21143
Serial channels will use a baud rate of 9600
TFTP SERVER PARAMETERS:
IP address of the TFTP host is 10.110.10.13
The file to download and start is m8240ram.arj
After board is reset, start-up code will wait 5 seconds
-------------------------------------------------------------------
(M)odify any of the 3Com router configuration or (C)ontinue? [M]
2 Enter C to confirm the selection and the router performs POST again, and the Boot
ROM starts normally.
3 The router performs POST, and the following displays:
3Com Router start booting
******************************************
* *
* 3Com Router Series Boot rom, V4.32 *
* *
******************************************
3Com Corporation Copyright(C) Reserved.
Compiled at 17:47:11 , Mar 21 2002.
Now testing memory...OK!
256M bytes SDRAM
8192k bytes flash memory
Press Ctrl-B to enter Boot Menu
Press Ctrl+B as prompted and the system enters the 3Com Router main software
upgrade menu.
The system enters the 3Com Router main software upgrade menu unless you
press Ctrl+B within three seconds of displaying “Press Ctrl-B to enter Boot
Menu...” on the screen. Otherwise, the system will start decompressing the
program. Reboot the router if you want to enter the 3Com Router main software
upgrade menu after program decompression is started.
4 Enter Ctrl+B and the system prompts:
Please input Bootrom password: