Filter
Top Products
Typical X.25 Configuration Example 233
II. Networking Diagram
Figure 75 Networking diagram of typical configuration of X.25 hunt group
III. Configuration Procedure
1 Configure RouterA
a Configure the link layer protocol of interface Serial1 to X.25 and specify it to
operate in DCE mode.
[Router]interface serial 1
[Router-Serial1]link-protocol x25 dce
b Configure the link layer protocol of other synchronous serial interfaces to X.25
and specify it to operate in DCE mode. Their configuration is identical to the
configuration of interface Serial 1.
c Configure IP addresses on interface Ethernet 0.
[Router]interface ethernet 0
[Router-Ethernet0]ip address 10.1.1.1 255.255.255.0
d Enable X.25 switching in system view.
[Router]x25 switching
e Create X.25 hunt group named hg1 with property of rotary in system view.
[Router]x25 hunt-group hg1 round-robin
f Add Serial 1, Serial 2 and XOT Tunnel to hunt group.
[Router-X25-huntgroup-hg1]interface serial 1
[Router-X25-huntgroup-hg1]interface serial 2
[Router-X25-huntgroup-hg1]channel xot 10.1.1.2
g Configure X.25 switching route whose forwarding address is hunt group hg1
and enable the substitution of destination address and source address.
[Router]x25 switch svc 2222 sub-dest 8888 sub-source 3333 hunt-group
hg1
h Configure X.25 switching route to forward to X.25 terminal.
[Router]x25 switch svc 1111 interface serial 3
[Router]x25 switch svc 1119 interface serial 11
2 Configure RouterB
a Configure the interface Serial0's link layer protocol to X.25 and specify it to
operate in DTE mode.
QuidwayA
QuidwayB
QuidwayC
QuidwayEQuidwayD
S1
S0
S2
S0
E0
E0
S0
S0
10.1.1.1
10.1.1.2
X.25 Terminal
huntgroup
2222
1111
8888
8888
8888
X.25 Terminal
X.25 Terminal
1112
1119
S3
S4
S11
RouterA
RouterB
RouterC
RouterD RouterE