Filter
Top Products
Configuration of DLSw 389
12 Configure to Stop Running DLSw
Please carry out the following configuration under overall view.
Table 439 Configure to stop running DLSw
By default, the system does not run DLSw protocol.
After using this command, the system will release all the dynamic resources but
reserve the existing configuration.
13 Configure Baud Rate of Sync Interface
All of the above commands are some of basic commands for configuring DLSw.
SNA equipment have diversified sorts and quite differences in the factual
environment. The following commands are some frequently used adjustment
parameters used to make the different equipment compatible.
Please process the following configurations in the synchronous interface view.
Table 440 Configure baud rate of synchronous Interface
By default, the baud rate of the serial interface on SNA equipment is 9600bps.
14 Configure Encoding Mode of Sync Interface
There are two kinds of encoding modes including NRZI and NRZ on the
synchronous serial interface. The routers in our company generally use NRZ
encoding mode, but the encoding mode of the serial ports in some SNA
equipment uses NRZI. So you need to change the encoding of routers according to
the encoding mode used by the connected equipment.
This command is used to change the encoding mode of synchronous serial
interface.
Please process the following configurations in the synchronous interface view.
Table 441 Configure encoding mode of synchronous Interface
By default, the synchronous interface uses encoding mode NRZ.
15 Configure Idle Time Encoding Mode of Sync Interface
The SDLC serial ports of the 3Com Router series of routers is identified with “7E”
during the idle time, but all of the serial ports on some SDLC equipment use high
level working status “1” during the idle time. To improve the compatibility with
the equipment, you need to change the idle time encoding mode of the routers.
Please process the following configurations in the synchronous interface view.
Operation Command
Enable running DLSw dlsw enable
Stop running DLSw undo dlsw enable
Operation Command
Configure baud rate of synchronous interface baudrate baudrate
Operation Command
Configure NRZI encoding mode of synchronous interface code nrzi
Delete NRZI encoding mode of synchronous interface undo code nrzi