Filter
Top Products
Configure Bridge’s Routing Function 305
Table 340 Configure bridge set to route or bridge the network layer protocol
By default, the bridging is enabled, the routing is disabled.
You can execute the display bridge bridge-set bridge-template
command to view the configuration of routing and bridging on each interface.
9 Configure Link-Set
a Define a link-set
The link set can bundle multiple parallel links between two bridges, thus
sharing loads among multiple links and enhancing link bandwidth utilization
ratio when there is no bridge loop
.
Perform the following configuration in interface view.
Table 341 Define a link-set
b Share load by source MAC address
Perform the following configuration in system view.
Table 342 Share load by source MAC address
By default, the load is shared by packets instead of source MAC address.
However, the load will be shared by source MAC address, if it is configured.
Executing the display bridge bridge-set link-set command can display
the configuration of the link-set on each bridge as well as whether it is sharing
the load.
10 Configure Bridging over Frame Relay
When establishing a bridge, mapping between the bridge address and DLCI
address should be specified.
Perform the following configuration in interface view.
Operation Command
Enable the bridge set to route the network layer
protocol
bridge bridge-set routing { ip
| ipx
}
Disable the bridge set to route the network layer
protocol
undo bridge bridge-set routing
{ ip | ipx
}
Enable the bridge set to bridge the network layer
protocol
bridge bridge-set bridging { ip
| ipx }
Disable the bridge set to bridge the network layer
protocol
undo bridge bridge-set bridging
{ ip | ipx
}
Operation Command
Assign a port to a link-set. bridge-set bridge-set link-set
link-set
Operation Command
Bind the ports to a link-set to share the load
by source MAC address
bridgebridge-set link-set link-set
origin
Disable the load sharing by source address undo bridge bridge-set link-set
link-set origin