Filter
Top Products
Command Line Interface (CLI) 23
The command line prompt character consists of the network device name (Router
by default) and the command view name, such as [Router-rip].
The commands are divided according to view. In general, in a certain view, only
the commands defined by the view can be executed, but some widely used
commands (including
ping, display, debugging, reset, save, interface,
logic-channel, and controller) can be executed in all views
For some views listed in the above table, you must enable the corresponding
functions before you can enter the views. To enter some other views, however,
you should configure the related restriction conditions. For more information, see
the related chapters in this manual.
In all views, you can use the quit command to return to the superior-level views,
and the return command to the system view directly.
Command Line
Online Help
The command line interface of the 3Com Router provides the following online
helps:
■ Full help
■ Partial help
X.25 hunt
group view
Configures the X.25
hunt group parameters
[Router-X25-huntgroup-abc] Enter x25
hunt-group abc
round-robin in
system view
Enter quit to return
to the system view
Frame Relay
class view
Configures the FR class
parameters
[Router-fr-class-abc] Enter fr class
abc in system view
Enter quit to return
to the system view
DLCI view Configures the DLCI
parameters
[Router-fr-dlci-100] Enter fr dlci 100
in synchronous serial
interface view. (The
link layer protocol
encapsulated on the
interface should be
FR.
Enter quit to return
to the synchronous
serial interface view
Frame Relay
switch view
Configures the FR
switch parameters
[Router-fr-switch-abc] Enter fr switch
abc in system view
Enter quit to return
to the system view
MFR interface
view
Configures the MFR
interface parameters
[Router-MFR0] Enter interface
mfr 0 in any views
Enter quit to return
to the system view
L2TP group
view
Configures L2TP group [Router-l2tp1] Enter l2tp-group
1 in system view
Enter quit to return
to the system view
IPSec proposal
view
Configures a security
proposal
[Router-ipsec-proposal-abc] Enter ipsec
proposal abc in
system view
Enter quit to return
to the system view
IPSec policy
view
Configures a security
policy
[Router-ipsec-policy-abc-0] Enter ipsec
policy abc 0 in
system view
Enter quit to return
to the system view
IKE proposal
view
Configures an IKE
proposal
[Router-ike-proposal-0] Enter ike
proposal 0 in
system view
Enter quit to return
to the system view
ACL view Configures ACL rules [Router-acl-1] Enter acl 1 in
system view
Enter quit to return
to the system view
DHCP address
pool view
Configures a DHCP
address pool
[Router-dhcpabc] Enter dhcp server
ip-pool abc in
system view
Enter quit to return
to the system view
View name Function Prompt Enter command Exit command