Filter
Top Products
Configure X.25 217
DCE equipment in X.25 networks to provide the function of load balancing for
DTE equipment) then configuration of X.25 load balancing needs to be made on
the routers.
The main configuration tasks of X.25 load balancing are as follows:
■ Start X.25 switching
■ Create X.25 hunt group
■ Add interfaces and XOT Tunnels to hunt group
■ Configure the X.25 switching route whose forward address is hunt group
■ Configure other X.25 switching routes
Hunt group addresses do not need separate configuration. Only the destination
addresses need to be set as hunt group addresses on source DTEs.
1 Start X.25 switching
Perform the following configuration in system view.
Table 260 Start /Close X.25 switching function
2 Create X.25 hunt group
Perform the following configuration in system view.
Table 261 Create/Delete X.25 hunt group
3 Add interfaces and XOT Tunnels to hunt group
Perform the following configuration in X.25 hunt group view.
Table 262 Add/Delete interfaces or XOT Tunnels in hunt group
It should be noted that a hunt group can have ten synchronous serial interfaces or
XOT Tunnels at most. XOT Tunnels cannot be added to the hunt group that adopts
vc-number channel selection policy.
4 Configure X.25 switching route which is forwarded to hunt group
Perform the following configuration in system view.
Operation Command
Start X.25 switching x25 switching
Close X. 25 switching undo x25 switching
Operation Command
Create X.25 hunt group x25 hunt-group hunt-group-name {
round-robin | vc-number }
Delete X.25 hunt group undo x25 hunt-group hunt-group-name
Operation Command
Add interfaces to hunt group channel interface interface-type
interface-number
Delete specified interfaces from hunt
group
undo channel interface
interface-type interface-number
Add XOT Tunnels to hunt group channel xot ip-address
Delete specified XOT Tunnels from hunt
group
undo channel xot ip-address