Filter
Top Products
DCC Configuration Examples 735
[Router-Bri0] dialer bundle-member 1
[Router-Bri0] dialer bundle-member 2
[Router-Bri0] link-protocol ppp
[Router-Bri0] ppp authentication-mode pap
2 Configure RouterB:
[Router] dialer-rule 2 ip permit
[Router] local-user usera password simple usera
[Router] interface dialer 0
[Router-Dialer0] ip address 100.1.1.2 255.255.255.0
[Router-Dialer0] undo dialer enable-circular
[Router-Dialer0] dialer bundle 1
[Router-Dialer0] dialer number 8810148
[Router-Dialer0] dialer user usera
[Router-Dialer0] dialer-group 2
[Router-Dialer0] ppp authentication-mode pap
[Router-Dialer0] ppp pap local-user userb password simple userb
[Router-Dialer0] interface bri 0
[Router-Bri0] undo dialer enable-circular
[Router-Bri0] dialer bundle-member 1
[Router-Bri0] link-protocol ppp
[Router-Bri0] ppp authentication-mode pap
3 Configure RouterC:
[Router] dialer-rule 1 ip permit
[Router] local-user usera password simple usera
[Router] interface dialer 0
[Router-Dialer0] ip address 122.1.1.2 255.255.255.0
[Router-Dialer0] undo dialer enable-circular
[Router-Dialer0] dialer bundle 1
[Router-Dialer0] dialer number 8810148
[Router-Dialer0] dialer user usera
[Router-Dialer0] dialer-group 1
[Router-Dialer0] ppp authentication-mode pap
[Router-Dialer0] ppp pap local-user userc password simple userc
[Router-Dialer0] interface bri 0
[Router-Bri0] undo dialer enable-circular
[Router-Bri0] dialer bundle-member 1
[Router-Bri0] link-protocol ppp
[Router-Bri0] ppp authentication-mode pap
DCC Application
Providing MP Binding
The local router is connected to the remote end via two ISDN BRI interfaces.The
traffic threshold must be set to distribute the traffic. Thus, the bandwidth
resources can be allocated according to the actual traffic. The maximum available
bandwidth is specified.
As shown in Figure 234, the ISDN BRI interfaces on RouterA and the ISDN PRI
interface on RouterB are connected through an ISDN network. RouterA must
adopt resource-shared DCC to call RouterB, and RouterB adopts circular DCC to
call RouterA. The addresses of RouterA and RouterB are 100.1.1.1 and 100.1.1.2,
respectively.