Filter
Top Products
Display and Debug Bridge 307
Table 349 Configure bridge on VLAN
Display and Debug
Bridge
Perform the reset, display and debugging commands in all views.
Table 350 Display and debug bridge
Typical Bridge
Configuration
Transparent Bridging
Multiple LANs
I. Networking Requirements
Suppose that there are several PCs located on the Ethernet segment LAN1 of a
building's floor and several PCs and servers on the Ethernet segment LAN2 of
another floor of the building. It is required to build the transparent bridge
between these two LANs.
Operation Command
Configure the bridge-set on the sub-interface
of VLAN
bridge-set bridge-set
Operation Command
Clear the statistics of access list rules reset acl counters [ acl-number ]
Clear the entries of all the bridge-sets or
specified groups in the forwarding database
reset bridge [ bridge-set ]
Clear the statistics of Spanning Tree reset stp statistics
Clear the traffic statistics of bridge-set on the
interface
reset bridge traffic
Display the states of all the bridge-sets display bridge-set [ bridge-set ]
Display the information in the bridge
forwarding database
display bridge information
Display the state and statistics of STP display bridge spanning-tree
Display the static data of bridge-set traffic on a
port
display bridge traffic
Display the routing and bridging configuration
on each interface
display bridge bridge-set
bridge-template
Display link set configuration of the specified
bridge set.
display bridgebridge-set link-set
Enable bridge-set debugging debugging bridge
Enable the spanning-tree protocol debugging debugging stp { error | event |
packet }