Filter
Top Products
132 CHAPTER 10: CONFIGURING WAN INTERFACE
Table 127 Enter the synchronous serial interface view
The following are to be set:
■ Operating parameters of data link layer protocol, such as PPP, Frame Relay,
LAPB or X.25.
■ IP address
■ The operating parameters of the standby center need to be set when the
interface serves as the main interface or standby interface of the standby
center.
■ The rules for address translation or packet filtering need to be set if the firewall
is to be set up on the interface.
For more details, refer to the related sections of this manual.
3 Bind the interface to be channel sets
Perform the following configurations in CE1/PRI interface view.
Table 128 Bind the interface to be channel sets
The timeslots can be bind to form up to 31 channel sets on a CE1/PRI interface.
The CE1/PRI interface can be bound to be channel sets only when it is enabled to
operate in CE1/PRI mode through the using ce1 command.
Only one timeslot binding mode is supported on one CE1/PRI at one time, that is,
the interface can only be bound into either channel sets or a pri set in that period.
After binding the interface to be channel sets, the system will automatically create
a Serial interface numbered serial number:set-number. This interface has the
same logic feature as that of a synchronous serial interface, and can be treated as
a synchronous serial interface for further configurations.
Perform the following configuration in all views.
Table 129 Enter the synchronous serial interface view
The following is to be set:
■ Operating parameters of data link layer protocol, such as PPP, Frame Relay,
LAPB or X.25.
■ IP address
■ The operating parameters of the standby center need to be set when the
interface serves as the main interface or standby interface of the standby
center.
Operation Command
Enter the synchronous serial interface view interface serial number:0
Operation Command
Bind the timeslots of CE1/PRI interface to a
channel set
channel-set set-number
timeslot-list range
Remove binding timeslots to form channel
sets
undo channel-set set-number
Operation Command
Enter the synchronous serial interface view interface serial
number:set-number