Filter
Top Products
220 CHAPTER 16: CONFIGURING LAPB AND X.25
Table 265 Start X.25 switching
1 By default, do not start X.25 switch.
2 Configure IP side interface
Because the XOT implements the connection of two X.25 nets through IP net, first
you should ensure that the IP net is expedite. For the specific configuration, refer
to chapters of Operation Manual - Network protocol.
3 Configure local switching (SVC)
For SVC, when it receives the packets from the remote side, it must send out the
packets through local switch interface, so you have to configure local switching.
The following commands determine: In SVC, through which switch interface the
packets getting to local side will be sent out.
Perform the following tasks in system view.
Table 266 Configure local switching
4 Configure XOT route
The following configuration determines how the X.25 side packets received are
forwarded through IP net. There are different views for SVC and PVC.
For SVC, perform the following tasks in system view.
Table 267 Configure SVC XOT switching
The local X.25 route must be configured in the SVC mode.
For PVC, perform the following tasks in interface view.
Operation Command
Enable X.25 switching x25 switching
Operation Command
Configure X.25 local switching x25 switch svc x.121-address [
sub-dest destination-address ] [
sub-source source-address ] interface
serial interface-number
Delete X.25 local switching undo x25 switch svc x.121-address [
sub-dest destination-address ] [
sub-source source-address ] [
interface serial interface-number ]
Operation Command
Configure a SVC XOT route x25 switch svc x.121-address [
sub-dest destination-address ] [
sub-source source-address ] xot
ip-address1 [ ip-address2 ] … [
ip-address6 ] [ xot-option ]
Delete a SVC XOT route undo x25 switch svc x.121-address [
sub-dest destination-address ] [
sub-source source-address ] [ xot
ip-address1 [ ip-address2 ] … [
ip-address6 ] ] [ xot-option ]