Filter
Top Products
396 CHAPTER 25: CONFIGURING DLSW
Table 463 Configure acknowledgement wait time T2 of SDLC secondary station
By default, the acknowledgement wait time T2 of SDLC secondary station is
configured to be 500 ms.
Display and Debug
DLSw
Table 464 Display and debug DLSw
Typical DLSw
Configuration
Example
DLSw Configuration of
LAN-LAN
I. Networking Requirement
LAN-LAN working mode is used. The two running SNA and LAN are connected by
IP across WAN.
Operation Command
Configure acknowledgement wait time T2 of SDLC
secondary station
sdlc timer lifetime
mseconds
Restore the default value of acknowledgement wait
time T2 of SDLC secondary station
undo sdlc timer lifetime
Operation Command
Display interface Bridge set information display dlsw bridge-entry
Display performance exchange information display dlsw information [
local ] [ ip-address
ip-address ]
Display Information about DLSw circuits running in the
router
display dlsw circuits [
circuit-id ] [verbose]
Display remote end peer entity information display dlsw remote [
ip-address ip-address ]
Clear entry buffer memory information of Bridge set reset dlsw circuits [
circuit-id ]
Clear virtual circuit information debugging dlsw circuit
Open debugging information switch of DLSw virtual
circuit
debugging dlsw core
Open debugging information switch of DLSw status
machine
debugging dlsw event
Open debugging information switch of DLSw abnormal
events
debugging dlsw packet
Open debugging information switch of DLSw messages debugging dlsw tcp
Open debugging information switch of DLSw peer
entity
debugging sdlc event
Open debugging information switch of SDLC events debugging sdlc packet
Open debugging information switch of SDLC messages display dlsw bridge-entry