Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 6-43
Electrical Installation
Verify Ethernet Cable Connection
Verify Ethernet Cable Connection
Verify Ethernet cable connection to network by observing the Ethernet link status indicator on the
rear panel (see Figure 6-28).
Requirement: Ethernet link status indicator lights green.
NOTE: If Ethernet status indicator does not light, the Access Navigator is not receiving
Ethernet pulses over the cable connection to the network. Check cable wiring and ensure
that other end of cable is connected to an active Ethernet hub or interface card.
Figure 6-28. Location of Ethernet Link Indicator
Verify Ethernet Management Connection
1. Verify Ethernet operation by initiating a Telnet session to the Access Navigator’s IP address. (This
can also be done remotely from the network operations center.) The Access Navigator should
respond with a message similar to the following. If necessary, press Return or Enter key to display
message:
Telnet session
Carrier Access Corporation Access Navigator
08:43:30 01/02/1998
Access Navigator>
Requirement: Access Navigator responds when Telnet session is initiated.
NOTE: If there is no response from the Access Navigator, refer to Diagnostics &
Troubleshooting on page 15-1.
Ethernet
Connector
Ethernet Link OK
Status Indicator