Carrier Access Access Navigator Network Router User Manual


 
15-14 August 2003 Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Status DS1 All
Description:
Status DS1 All
Displays an abbreviated list showing the status for all 32 DS1 circuits. It produces a message similar to
the following, showing the DS1 number, current status, and some common parameters of interest in
trouble-shooting. (To obtain a detailed list for a specific DS1 or range of DS1s, use the status ds1
<n> command.)
Syntax: status ds1 all
Item Description
Receive Traffic – normal operation.
(The CLI also shows alarm conditions.)
Transmit Traffic – normal operation.
(The CLI also shows alarm conditions.)
Loop None – normal operation.Line – line loopback.
Payload – payload loopback.
State In use as DROP – Subscriber “drop” DS1.
In use as GROOM – DCS “groom” DS1.
In Service – GR-303 “switch” DS1.
User set Out of Service – User set DS1 down.
Card Not Installed – Empty card slot
(The CLI also displays alarm messages such as RAI.)
FDL Type None – No detection or response (only option for switch DS1s).
SLC96 – Required for Shelf A of SLC-96/TR-08 group.
T1403 – Detects and responds to ANSI T1.403 codes.
(See Set DS1 FDL on
page 18-106.)
Remote Device
Mgmt Type
None – no management
CA FDL – Used to provision remote Access Bank II or
establish pass-through management session to Adit 600.
CA IP <ipaddress> – Used for IP DS0 management of
remote Adit 600.
CA DS1 <n> – Used for IP DS0 management of remote
Adit 600.
(See Set DS1 Remote Device Mgmt on
page 18-113.)
Remote Device Mgmt
Status
Up or Down – Shown only if Remote Device Mgmt Type is CA
IP or CA FDL.