Carrier Access Access Navigator Network Router User Manual


 
6-62 August 2003 Access Navigator - Release 1.8
Electrical Installation
Start RS-232 Management Session
Start RS-232 Management Session
NOTE: Security – No names or passwords are required for new installation and initial
turn up. The Access Navigator will accept any user, until password security is turned on.
NOTE: Command Line Interface – The Access Navigator operating system provides a
Command Line Interface (CLI), which uses simple text based commands and messages.
See Command Line Interface Conventions on page 7-3 for a short description of the
conventions used in this manual to represent management commands, settings, and
messages. For additional information, see CLI Language Reference on page 18-1.
1. Configure computer terminal emulation software, or craft terminal, as follows:
Terminal emulation: ANSI, ASCII, VT100
Flow control: None
Send mode: echo characters locally
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
NOTE: In the following step, it is only important that the Access Navigator respond with
a message. A typical message includes the name of the unit, the time and date, and a
prompt.
2. Initiate RS-232 management session by pressing keyboard Enter or Return key.
Carrier Access Corporation Access Navigator
08:30:45 01/30/1999
Access Navigator>
Requirement: Access Navigator message appears on computer or craft terminal display.
NOTE: If there is no response from the Access Navigator, refer to Diagnostics &
Troubleshooting on page 15-1.