Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 18-15
CLI Language Reference
Managing Users
Managing Users
CLI provides the manager with commands to show current users, add and delete users, and set access
levels and passwords.
n Who Am I ... 18-15
n Show Users ... 18-15
n Add User ... 18-16
n Set User Access Level ... 18-16
n Set User Password ... 18-17
n Delete User Password ... 18-17
n Delete User ... 18-17
Who Am I
The whoami command shows the name and access level of the user who is logged into the Access
Navigator from the current management terminal. It produces a message similar to that shown
below.
Syntax: whoami
Message: Logged in as user 'alice' (level 1)
Show Users
NOTE: Normally a user logs in once to start a management session, then logs off when
done (exit command). The system allows the same user name to be “logged in” more
than once. The total number of simultaneous sessions by all users can not exceed 3,
comprising a maximum of 1 RS-232 session and 2 Telnet sessions.
Show current user settings and status with the following command.
Syntax: show users
The following is a typical message showing four users. Alice and Bill have level 1 (manager)
access. Carl Smith has level 2 (operator) access. And Dave46 has level 3 (monitor) access. The
message also gives the current login status and the time and date that each user last logged into the
system.
Message:
User Level Logged in Last Login
---- ----- --------- ----------
alice 1 1 09:28:37 11/23/1998
bill 1 2 14:06:25 11/17/1998
carlsmith 2 0 11:17:45 11/22/1998
dave46 3 0 12:14:33 11/20/1998