Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 18-173
CLI Language Reference
CLI Command List
Message:
DS1 Terminal ID Status
--- -------------------- ---------------------- --------------
1 CA Adit 600 Remote Device #1 In Service as CA IP
In Service as PPHONE
2 n/a n/a FDL Not Used
3 CA Access Bank I Remote#3 In Service as CAC
4 CA Access Bank II Remote#4 In Service as CAC
5 CA Adit 600 Remote#5 In Service as CA FDL
6 Unknown Unknown In Service as T1403
7 Unknown n/a Facility failure
Description:
Status TMC
Purpose: Provides detailed TMC service status message for the current 1-hour interval. (For
status information for other hours, see Status TMC History on page 18-175.)
Security: Level 3 (monitor)
Syntax: status tmc
Message:
TMC Status:
Primary
Channel: DS1 #25 channel 24
Link Status: Up
Mode: Active
Item Description
DS1 DS1 number, 1 to 32
Terminal n/a – (not applicable) FDL is not being used.
CA Access Exchange
CA Access Bank I
CA Access Bank II
CA Adit 600
Unknown – FDL is being used by unknown terminal.
ID Remote Terminal Identifier
Status In Service as CA FDL – FDL is up and using FDL protocol.
In Service as CA IP – DS0 link is up and using CA IP protocol.
Negotiating IP Link – Trying to establish CA IP link.
Facility Failure – CA IP link can not be established.
In Service as PPHONE – P-Phone call connection is enabled.
In Service as T1403 – FDL is up and using ANSI T1.403.
FDL Not Present – FDL protocol is set to "none".
FDL In Progress – Transmitting.
Facility failure – FDL is Out of Service.