16-18 August 2003 Access Navigator - Release 1.8
Maintenance Procedures
Replace Unprotected Controller Card
.
Figure 16-8. Location of Front Panel Controller Status LEDs
Remove Old Controller
1. On old standby Controller card, press ejector latches in toward outside of card until card connector
releases with backplane connector (see Figure 16-7).
2. Slide old standby Controller out of card slot and set aside for return to repair facility.
3. End management session by entering following command:
exit
Replace Front Cover
DANGER! FIRE HAZARD. STANDARDS UL 1950 AND C22.2 NO. 950.95 REQUIRE
THAT ALL ACCESS COVERS BE REPLACED TO PREVENT FIRES FROM SPREADING TO
NEARBY EQUIPMENT.
Replace front cover and tighten screws.
Controller ’A’ Indicators Controller ’B’ Indicators
Active
Controller
Power