16-34 August 2003 Access Navigator - Release 1.8
Maintenance Procedures
Install SIMM on Controller Card
Figure 16-16. Installing Controller Card SIMM
NOTE: If status indications are not correct, refer to Diagnostics & Troubleshooting on
page 15-1.
9. Verify power-on status of upgraded Controller. The LED indicators should be as follows:
Requirement: Upgraded CONTROLLER POWER indicator lights green.
10. Wait two minutes for upgraded Controller to learn system settings.
11. Verify upgraded Controller status by entering the following command:
status equipment
Requirement: Upgraded Controller status is “Standby”.
12. Put upgraded Controller into active mode by entering following command:
Card Ejector
Latches
C
D
Notch
SIMM
SIMM
Socket
E
A
SIMM
Socket
B
Eject
Lock