Filter
Top Products
9-6 August 2003 Access Navigator - Release 1.8
Provision DCS Service
DCS Provisioning Quick Guide
DCS Provisioning Quick Guide
CLI Commands Descriptions
status equipment Verify equipment configuration.
show ds1 <n|all>
status ds1 <n>
status ds0 <n:ch>
Verify service status.
set ds1 <n> down
set ds0 <n:ch> down
set ds0 <n:ch> type <voice|data>
Set unused circuits out of service
(down). If the DS1 is not terminated,
set the DS0 type of all channels to
data. If the DS1 is terminated, set the
DS0 type of any unused channels to
match the DS0 type (voice or data)
configured on the device at the other
end of the DS1.
set clock1 <bits|ds1 n|internal> Primary system clock source.
set clock2 <bits|ds1 n|internal> Secondary system clock source.
set ds1 <n> type <groom|drop> DS1 type.
set ds1 <n> framing <d4|esf> DS1 framing.
set ds1 <n> linecode <ami|b8zs> DS1 line code.
set ds1 <n> id <"id"> DS1 identifier.
set ds1 <n> clock <normal|loop> DS1 clock source.
set ds1 <n> lbo <setting> DS1 line buildout.
set ds1 <n> loopdetect <on|off> Usually off for drop DS1s.
show connect <n> Verify DS0 crossconnections.
disconnect <n:ch> Remove old DS0 connections.
set ds0 <n:ch> type <voice|data> DS0 type (use data type for ISDN PRI
passthrough).
set ds0 <n:ch> signal <ls|gs|em> DS0 signaling (voice type only).
connect <n:ch> <n:ch> Add DS0 crossconnections.
set ds0 <n:ch> up Set DS0s in service.
set ds1 <n> up Set DS1s in service.