Access Navigator - Release 1.8 August 2003 14-15
Alarm Clearing
Clear Alarms – Status Indicators
Clear Alarms – Status Indicators
Find indicator in following list and go to the alarm clearing procedure:
l POWER indicator – go to Power Status LEDs on page 14-16
l ACTIVE indicator – go to Active/Standby Controller Status LEDs on page 14-17
l CRITICAL indicator – go to Critical Alarm Status LEDs on page 14-18
l MAJOR indicator – go to Major Alarm Status LEDs on page 14-18
l MINOR indicator – go to Minor Alarm Status LEDs on page 14-19
l ACO indicator – go to Alarm Cutoff (ACO) Status LED on page 14-19
l DSI indicator – go to DS1 Status LEDs on page 14-20
l Ethernet indicator (on rear panel) – go to Ethernet Link Status LED on page 14-21
NOTE: Alarm and equipment status can also be determined using CLI commands. See
Clear Alarms – FDL on page 14-3.
Figure 14-1. Front Panel Indicators (Ethernet Indicator is on Rear Panel)
Controller ’A’ Indicators Controller ’B’ Indicators
Critical, Major, Minor
Alarm Indicators
Power and
Active/Standby
Indicators
Alarm Cutoff (ACO)
Pushbutton and Indicator
DS1 Status Indicators (1 to 32)