![](http://pdfasset.owneriq.net/e/bb/ebbb0037-9847-422c-a43b-1d7b53a2e01c/ebbb0037-9847-422c-a43b-1d7b53a2e01c-bg29a.png)
C-8 August 2003 Access Navigator - Release 1.8
SNMP Interface
SNMP Requirements
SNMP Requirements
CLI commands must be used to configure the Access Navigator for SNMP operation. In particular, the
operator must set up the Ethernet port, SNMP community strings, and NMS IP addresses. (See CLI
Language Reference on page 18-1.) SNMP configuration includes the following items.
NOTE: To provide secure access, community strings are required for SNMP
management, but can not be changed or displayed using SNMP set and get commands.
Access attempts using invalid community names will be trapped and reported to the NMS.
* Contact and location can be changed through objects in the standard SNMP System Group.
† NMS IP addresses can be changed through objects in the Carrier Access Enterprise MIB.
Table C-3 SNMP Configuration Items
Commands Descriptions
set ethernet ip address Ethernet IP address and mask
set ip gateway Gateway IP address
set snmp contact System contact *
set snmp location System location *
set snmp getcom Get community
set snmp setcom Set community
set snmp trapcom Trap community
set snmp nms NMS IP address (up to 3) †