Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 18-11
CLI Language Reference
Context Sensitive Help
Context Sensitive Help
NOTE: Context sensitive help does not work for command words taken out of context.
All CLI commands consist of one or more words typed in a specific order. You can obtain
help for a partial command only if you type the key command words in sequential order,
starting with the first word in the command. For example, in the command word sequence
set ds1 6 framing esf, you can only obtain context sensitive help for the partial
commands set, set ds1, and set ds1 framing. Help is not available for the individual
words ds1 or framing or esf.
Help for a specific CLI command is available either by typing help before the command word or
words in the partial command pressing the Enter or Return key. It is usually easier to type a question
mark ? after the partial command (no need to press the Enter or Return key). For example, typing set
? and pressing the Enter or Return key will produce a message similar to the following.
Access Navigator> help set
or
Access Navigator> set ?
set ......................... Configure an interface.
alarms ................... Manually set an alarm state for testing.
clock1 ................... Set the primary
master transmit clock source.
clock2 ................... Set the secondary
master transmit clock source.
crv ...................... Set CRV call state.
date ..................... Sets the date in month/day/year.
ds0 ...................... Setup the specified DS0s of a DS1.
ds1 ...................... Setup the specified DS1.
eoc ...................... Setup the EOC interface to the IDT.
ethernet ................. Set ethernet ip address.
id ....................... Set the ID.
ip ....................... Set ip gateway.
remote ................... Set remote terminal properties.
screen ................... Set/Display CRT screen size in lines.
snmp ..................... Set the SNMP MIB-II System Group objects.
switch ................... Set switch type
time ..................... Sets the time in hrs:mins:secs
Note: use int'l format (24-hour).
tmc ...................... Setup the TMC interface to the IDT.
user ..................... Modify attributes for a particular user.
Access Navigator> set
NOTE: The partial command will be repeated at the prompt so that you can enter
additional command words from the help list. Press the Escape key to cancel the partial
command and go back to a blank prompt.