Carrier Access Access Navigator Network Router User Manual


 
10-28 August 2003 Access Navigator - Release 1.8
Provision GR-303 Service
Provision ISDN BRI 4:1 TDM Service to Subscribers
7. Show current ISDN BRI connections with the following command:
show connect <n>
Example: show connect 10
The show connect command will display the settings for the DS1 specified. For example, the
message for showing connections for DS1 #10 would look similar to the following:
Connections for DS1 #10 (CA DS1# 10):
From To Type Interface [--> Port]
---- ----- ----- --------------------
10:01 ..... GR303
10:02 ..... GR303
10:03 ..... GR303
10:04 ..... GR303
10:05 ..... GR303
10:06 ..... GR303
10:07 ..... GR303
10:08 ..... GR303
10:09 25:17 GR303
10:10 ..... GR303
10:11 ..... GR303
10:12 ..... GR303
10:13 .....
10:14 .....
10:15 .....
10:16 .....
10:17 09:12 DATA AcmeInternet --> V.35
10:18 09:13 DATA AcmeInternet --> V.35
10:19 09:14 DATA AcmeInternet --> V.35
10:20 09:15 DATA AcmeInternet --> V.35
10:21 09:16 DATA AcmeInternet --> V.35
10:22 09:17 DATA AcmeInternet --> V.35
10:23 09:18 DATA AcmeInternet --> V.35
10:24 09:19 DATA AcmeInternet --> V.35
NOTE: The above message shows that DS1 #10 channels 1 to 12 are type GR303 and
that channel 9 is connected to switch DS1 #25. Only ISDN BRI D channels can be statically
connected to a switch DS1. DS0s carrying active calls will appear as connections to switch
DS0s.
8. If drop ISDN BRI D channel connections are correct, skip remaining steps