Carrier Access Access Navigator Network Router User Manual


 
12-8 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via FDL
Verify Equipment Configuration
NOTE: Commands containing ds1 <n> require the operator to enter a DS1 number or
range of numbers. For example, DS1 #6 is entered as ds1 6. If a DS1 range is specified,
the command operations will be applied to all DS1s in the range. To enter a range of DS1s,
type the starting and ending numbers, separated by a hyphen. For example, DS1s #1
through #8 can be specified by typing ds1 1-8.
6. Show current DS1 status with the following command, where <n> is the DS1 or range of DS1s to
be turned up:
status ds1 <n>
Example: status ds1 1
This command will produce a message listing the status of the specified DS1 or range of DS1s. For
example, the message for DS1 #9 and #32 might look similar to the following. Note that the
message for DS1 #9 shows the DS1 is in service, while the message for DS1 #32 indicates there is
no Quad Framer circuit card installed.
Status for DS1 9:
Receive: Traffic
Transmit: Traffic
Loop: None
State: In use as DROP
FDL Type: None
Remote Device Mgmt Type: CA FDL
Status for DS1 32:
Receive: Traffic
Transmit: Traffic
Loop: None
State: Card Not Installed
FDL Type: None
Remote Device Mgmt Type: None
7. Verify status of DS1 lines to be turned up by comparing DS1 status with office records. If there is
a discrepancy, follow standard practices to resolve problem.
8. Verify current status of any remote devices with the following command, where <n> is the DS1 or
range of DS1s to be turned up:
status remote <n|all>
Example: status remote 1
This command will produce a message listing the remote terminals at the far end of the DS1s.
DS1 Terminal ID Status
--- -------------------- ---------------------- --------------
1 CA Adit 600 Remote Device #1 In Service as CA FDL