Filter
Top Products
12-4 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via FDL
Remote Adit 600 FDL Provisioning Quick Guide
Remote Adit 600 FDL Provisioning Quick Guide
CLI Commands Descriptions
status equipment Verify equipment configuration.
show ds1 <n>|all>
status ds1 <n>
status ds0 <n:ch>
Verify service status.
set ds1 <n> down
set ds0 <n:ch> down
set ds0 <n:ch> type <voice|data>
Set unused circuits out of service
(down). If the DS1 is not terminated,
set the DS0 type of all channels to
data. If the DS1 is terminated, set the
DS0 type of any unused channels to
match the DS0 type (voice or data)
configured on the device at the other
end of the DS1.
set ds1 <n> type drop DS1 type for remote Adit 600.
set ds1 <n> framing <d4|esf> DS1 framing. Use ESF for FDL.
set ds1 <n> linecode <ami|b8zs> DS1 line code. Use B8ZS for FDL.
set ds1 <n> id <"id"> DS1 identifier.
set ds1 <n> clock <normal|loop> DS1 clock source.
set ds1 <n> fdl none DS1 FDL type for remote Adit.
set ds1 <n> remote device mgmt cafdl Set drop DS1 to remote Adit on to use
Carrier Access FDL protocol.
set ds1 <n> remote device mgmt ds1 <n> Set all other drop DS1s to same
remote Adit to point to DS1 using
CAFDL.
set ds1 <n> lbo <setting> DS1 line buildout.
set ds1 <n> loopdetect <on|off> Usually off for drop DS1s.
show connect <n> Verify DS0 crossconnections.
disconnect <n:ch> Remove old DS0 connections (if any).
set ds0 <n:ch> type <voice|data|gr303> DS0 type.
set ds0 <n:ch> signal <ls|gs|em> DS0 signaling (voice or GR-303 types
only).
connect <n:ch> <n:ch> Add DS0 crossconnections.