Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 4-13
Access Navigator / GR-303 Host with P-Phone
GR-303 Signaling
GR-303 Signaling
l GR-303 ABCD robbed-bit signal codes
l GR-303 Direct Inward Dial (DID) signaling for Lucent switches
l GR-303 4:1 TDM mode support for ISDN BRI
l GR-303 P-Phone (EBS) signaling for Nortel switches
l FXS loop start and ground start
DCS Signaling
l Robbed-bit and clear channel connections at DS0 level
l FXS/FXO loop start and ground start
l E&M robbed bit signaling
Management Interfaces
l Command line interface (CLI) for provisioning and maintenance
l RS-232 interface for local CLI
l Ethernet Telnet support for remote CLI
l Ethernet SNMP uses Telcordia® standard MIB for DS1 interfaces (RFC-1406)
l TFTP and Xmodem support for flash memory software upgrades
Protocols
l Command Line Interface (CLI)
l Simple Network Management Protocol (SNMP)
l Telcordia® GR-303
l Nortel NIS V202-1, Issue 01 (P-Phone)
l Telnet
l TFTP and Xmodem support for flash memory software upgrades
Alarms
l Critical, Major, and Minor alarm levels
l DS1 alarms for LOS, LOF, AIS, and RAI
l Front panel LED indicators
l Output signal: relay contact closure and LED indication
Maximum relay contact rating: 110V AC or DC @ 1A
l Alarm inputs from dry contact closures
Maximum input rating: 60V DC