Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 9-17
Provision DCS Service
Provision and Connect DS0s
Provision and Connect DS0s
1. Show current DS0 crossconnections with the following command:
show connect <n>
Example: show connect 10
The show connect command displays DS0 crossconnections on a DS1. For example, the mes-
sage for DS1 number 25, DS0 channels 1 to 4 would look similar to the following:
Connections for DS1 #10 (CA DS1# 10):
From To Type Interface [--> Port]
---- ----- ----- --------------------
10:01 ..... GR303
10:02 ..... GR303
10:03 ..... GR303
10:04 ..... GR303
10:05 ..... GR303
10:06 ..... GR303
10:07 ..... GR303
10:08 ..... GR303
10:09 25:17 GR303
10:10 ..... GR303
10:11 ..... GR303
10:12 ..... GR303
10:13 .....
10:14 .....
10:15 .....
10:16 .....
10:17 09:12 DATA AcmeInternet --> V.35
10:18 09:13 DATA AcmeInternet --> V.35
10:19 09:14 DATA AcmeInternet --> V.35
10:20 09:15 DATA AcmeInternet --> V.35
10:21 09:16 DATA AcmeInternet --> V.35
10:22 09:17 DATA AcmeInternet --> V.35
10:23 09:18 DATA AcmeInternet --> V.35
10:24 09:19 DATA AcmeInternet --> V.35
2. If DS0 crossconnections are correct, skip remaining steps.
NOTE: To change existing DS0 connections or DS0 Type, you must first disconnect
them before making new connections.
3. Disconnect existing DS0s with the following command:
disconnect <n:ch>
Example: disconnect 10:1-24