Access Navigator - Release 1.8 August 2003 18-157
CLI Language Reference
CLI Command List
Status CRV
Purpose: Displays the status of the specified CRV number.
NOTE: In the following command, there can be up to 24 CRVs in a range,
such as 1-24 or 110-134. The CRVs do not have to be on the same DS1.
Security: Level 3 (monitor)
Syntax: status crv <range>
Example: status crv 10
Example: status crv 5-8
Message:
CRV Status Call Status
--- ------ -----------
4 Not Assigned
5 In Service Active
6 In Service Active
7 In Service Idle
8 In Service Permanent
9 Assigned to ISDN
Description:
Field Description
range Call Reference Value, 1 to 768, or a range of values such as 15-
18. Maximum range is 24 CRVs.
Item Description
CRV Call reference value, 1 to 768
Status The following states may occur:
Not Assigned
Not Available
Assigned to ISDN
In Service
User set Out of Service
Switch set Out of Service
Card not Installed
Facility failure
DS1 Out of Service
Call Status The following states may occur when CRV is In Service:
Active – Call in progress (off hook)
Idle – Line available (on hook)
Permanent – Line not available because of permanent off-hook
state