Carrier Access Access Navigator Network Router User Manual


 
13-4 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via IP DS0
Remote IP DS0 Provisioning Quick Guide
Remote IP DS0 Provisioning Quick Guide
Access Navigator CLI Commands Descriptions
status equipment Verify equipment configuration.
show ds1 <n>|all>
status ds1 <n>
status ds0 <n:ch>
Verify service status.
set ds1 <n> down
set ds0 <n:ch> down
set ds0 <n:ch> type <voice|data>
Set unused circuits out of service
(down). If the DS1 is not terminated,
set the DS0 type of all channels to
data. If the DS1 is terminated, set the
DS0 type of any unused channels to
match the DS0 type (voice or data)
configured on the device at the other
end of the DS1.
set ethernet <ipaddress> Set Ethernet IP address.
set ip gateway <ipaddress> Set gateway to router’s IP address.
set ds1 <n> type groom
set ds1 <n> type drop
DS1 type for router.
DS1 type for remote Adit.
set ds1 <n> framing <d4|esf> DS1 framing is ESF for remote Adit.
set ds1 <n> linecode <ami|b8zs> DS1 line code (b8zs is default).
set ds1 <n> fdl <none|slc96|t1403> DS1 fdl is none for remote Adit.
set ds1 <n> remote device mgmt caip Set DS1 remote device management to
use IP address of remote Adit.
set ds1 <n> remote device mgmt caip
<ipaddress> [pphone]
Set DS1 remote device management to
use IP address of remote Adit and
enable P-Phone service.
set ds1 <n> remote device mgmt ds1 <n> Set all other drop DS1s to same
remote Adit to point to DS1 above.
set ds1 <n> id <"id"> DS1 identifier.
set ds1 <n> clock <normal|loop> DS1 clock source.
set ds1 <n> lbo <setting> DS1 line buildout.
set ds1 <n> loopdetect <on|off> Usually off for drop DS1s.
show connect <n> Verify DS0 crossconnections.
disconnect <n:ch> Remove old DS0 connections (if any).
set ds0 <n:ch> type data
set ds0 <n:ch> type <voice|data|gr303>
DS0 type for management channel
DS0 types for other channels.
set ds0 <n:ch> signal <ls|gs|em> DS0 signaling (voice or GR-303 types
only).
connect <n:ch> <n:ch> Crossconnect management DS0.