Filter
Top Products
18-50 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Read Remote Log
Purpose: Retrieves and displays the log from the remote Access Bank II at the far end of the DS1.
The Access Bank II must be operational to read its log. The command displays a
message similar to the following. To erase all log entries, use the clear remote log
command. (See “Clear Remote Log” on page 28.)
NOTE: This command only displays the most recent 18 log events. The
Access Bank II records the most recent 2048 events in nonvolatile memory,
which is protected from power failures. To see the complete log, you will need
a direct CLI connection to the unit’s RS-232 port.
Security: Level 3 (monitor)
Syntax: read remote <n> log
Example: read remote 9 log
Message:
Event Log:
Time Date Description
-------- ---------- ---------------------------------------------------
1) 23:21:15 01/04/1996 t1drop (T1#2) - First time Unavailable for a Second
2) 23:21:14 01/04/1996 t1drop (T1#2) - First time available for a Second
3) 23:06:15 01/04/1996 t1drop (T1#2) - First time Unavailable for a Second
4) 23:06:14 01/04/1996 t1drop (T1#2) - First time available for a Second
5) 22:51:15 01/04/1996 sys - Remote Monitor Login
6) 22:51:13 01/04/1996 sys - V.35 I/F Operational
7) 22:36:14 01/04/1996 sys - Codec I/F Operational
8) 22:36:13 01/04/1996 sys - T1 Framer I/F Operational
9) 22:21:14 01/04/1996 sys - SCC I/F Operational
10) 22:21:13 01/04/1996 sys - First time available for a Second
11) 22:06:14 01/04/1996 sys - Memory Good
12) 22:06:14 01/04/1996 sys - Power Up or Reset
13) 21:52:12 01/04/1996 sys - Low Power and/or Brown-Out Conditions
14) 21:51:29 01/04/1996 t1 (T1#1) - Yellow Alarm not being received
15) 21:51:28 01/04/1996 t1 (T1#1) - Signal Restored (Carrier Present)
16) 21:51:23 01/04/1996 t1drop (T1#2) - First time Unavailable for a Second
17) 21:51:18 01/04/1996 t1drop (T1#2) - Loss of Framing
18) 21:51:16 01/04/1996 t1 (T1#1) - Received Yellow Alarm
NOTE: The Access Bank II has two T1 interfaces, called T1 #1 and #2, or
DS1 #1 and #2. The Access Navigator DS1 connects to one T1, and the other
may be used as a T1 Drop to customer equipment. In the Access Bank II/SDSL,
the SDSL interface replaces T1#2.
Field Description
n DS1 number, 1 to 32.