Carrier Access Access Navigator Network Router User Manual


 
Access Navigator - Release 1.8 August 2003 12-11
Provision Remote Adit 600 via FDL
Provision Drop DS1s to Remote Adit 600
4. Set DS1 type to “drop”
set ds1 <n> type drop
Example: set ds1 1 type drop
5. Set DS1 framing to ESF or D4 (SF). Use ESF for FDL management.
set ds1 <n> framing esf
Example: set ds1 1 framing esf
6. Set DS1 line code
set ds1 <n> linecode <ami|b8zs>
Example: set ds1 1 linecode esf
7. Set drop DS1 clock source to normal or loop
set ds1 <n> clock <normal|loop>
Example: set ds1 10 clock normal
8. Set DS1 FDL type to none.
set ds1 <n> fdl none
Example: set ds1 1 fdl none
9. Set DS1 remote device management type to use CAFDL for Carrier Access FDL management.
set ds1 <n> remote device management cafdl
Example: set ds1 1 remote device management cafdl
10. Set all other drop DS1s to same remote Adit to point to DS1 using CAFDL.
set ds1 <n> remote device mgmt ds1 <n>
Example: set ds1 1 remote device management cafdl
11. Set drop DS1 line buildout (lbo) to required DSX-1 equalization or CSU attenuation
set ds1 <n> lbo <setting>
Example: set ds1 1 lbo 1
The setting is a number from 1 to 9, and is defined as follows:
Setting
Definition
1 Set DSX-1 equalization for 0-133 ft.
2 Set DSX-1 equalization for 133-266 ft.
3 Set DSX-1 equalization for 266-399 ft.
4 Set DSX-1 equalization for 399-533 ft.
5 Set DSX-1 equalization for 533-666 ft.
6 Set CSU attenuation for LBO of 0dB.
7 Set CSU attenuation for LBO of -7.5dB.
8 Set CSU attenuation for LBO of -15dB.
9 Set CSU attenuation for LBO of -22.5dB.
NOTE: When loop code detection is turned on, the Access Navigator will respond to
T1.403 ESF bit patterned loop requests. Loop detection is normally turned off for DS1
drops.