Carrier Access Access Navigator Network Router User Manual


 
13-18 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via IP DS0
Provision Groom DS0s to Adit Router
Provision Groom DS0s to Adit Router
NOTE: Commands such as ds0 <n:ch> require the operator to enter both the DS1
and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as
ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0
channels are separated by a hyphen.
1. Show current DS0 settings with the following command:
show ds0 <n:ch>
Example: show ds0 32:1-4
The show command will produce a status message for each DS0 specified. For example, the mes-
sage for DS1 number 32, DS0 channel 10 would look similar to the following:
Settings for DS1 32, Channel 10:
Type: DATA
Signaling: NONE
Up/Down: UP
CRV: 320 (assigned but not available)
ISDN: none
2. If groom DS0 settings are correct, skip remaining steps.
3. Set DS0 type to data for IP DS0 management
set ds0 <n:ch> type data
Example: set ds0 32:6 type data
Example: set ds0 32:1-24 type data
4. Set DS0 in service
set ds0 <n:ch> up
Example: set ds0 10:1-24 up