Carrier Access Access Navigator Network Router User Manual


 
13-10 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via IP DS0
Verify Equipment Configuration
NOTE: Commands containing ds1 <n> require the operator to enter a DS1 number or
range of numbers. For example, DS1 #6 is entered as ds1 6. If a DS1 range is specified,
the command operations will be applied to all DS1s in the range. To enter a range of DS1s,
type the starting and ending numbers, separated by a hyphen. For example, DS1s #1
through #8 can be specified by typing ds1 1-8.
6. Show current DS1 status with the following command, where <n> is the DS1 or range of DS1s to
be turned up:
status ds1 <n>
Example: status ds1 10
This command will produce a message listing the status of the specified DS1 or range of DS1s. For
example, the message for DS1 #10 and #11 might look similar to the following. Note that the mes-
sage for DS1 #10 shows the DS1 is in service, while the message for DS1 #11 indicates there is no
Quad Framer circuit card installed.
Status for DS1 10:
Receive: Traffic
Transmit: Traffic
Loop: None
State: In Service
FDL Type: None
Status for DS1 11:
Receive: Traffic
Transmit: Traffic
Loop: None
State: Card Not Installed
FDL Type: None
7. Verify status of DS1 lines to be turned up by comparing DS1 status with office records. If there is
a discrepancy, follow standard practices to resolve problem.