Filter
Top Products
Parameters and Options
Action
Determines the disposition of IP datagrams, UDP datagrams, or TCP segments
meeting the filter rule.
Default: Drop
Accept
Relays a packet meeting the filter rule.
Drop
Discards a packet meeting the filter rule.
Action on circuit group
enable/disable
Determines the action taken with the Conditional Circuit Group.
Default: disable/enable
disable/enable
Enables the conditional static routing when the conditional circuit group is disabled.
When the conditional circuit group is restored, the conditional route is disabled.
enable/disable
Enables the conditional static routing when the conditional circuit group is enabled.
When the conditional circuit group goes down, the conditional route is disabled.
Acquisition Mode
Specifies which of two neighbors initiates EGP connections. EGP connections are
initiated when one neighbor issues an acquisition request message, and finalized
when the recipient of the acquisition request message issues an acquisition
confirmation response. A neighbor who issues acquisition request messages is said
to be active; a neighbor responding to such messages is said to be passive. Although
the EGP protocol allows both neighbors to be active, protocol efficiency is enhanced
when one neighbor is active and the other is passive.
Default: Active
Active
Assigns the router as an Active neighbor.
Passive
Assigns the router as an Passive neighbor.
Address Mask Reply
Enables or disables the generation of ICMP address mask reply messages when the
router boots and in response to valid address mask request messages.
Default: No
No
Disables address mask reply messages.
Internet Protocol (IP) Parameters
Parameters and Options
7-6