Filter
Top Products
Drop All
Sends no event messages.
Just MAJOR
Sends major event messages only.
Not INFO
Sends major, performance, and warning event messages.
PERF and MAJOR
Sends major and performance event messages.
Show All Events
Sends major, performance, warning, and information event messages.
Flow Control
Enables XON/XOFF flow control and sets the type of XON/XOFF flow control for
connect sessions made through the router Console port.
XON/XOFF flow control is a software method of controlling flow control
negotiation, and CTS/RTS is the hardware method of controlling flow control
negotiation. The flow control negotiation method used by the remote device must
match the router setting.
Default: XON/XOFF
None
Disables XON/XOFF software flow control and uses CTS/RTS hardware flow
control instead.
XON/OFF
Enables XON/XOFF software flow control.
Robust XON/XOFF
Enables XON/XOFF software flow control and sends out periodic XON signals
when the flow of data stops and the router expects to receive more data
(checksum failure). For example, the remote connection might have dropped (lost)
an XON signal sent by the router and could be waiting for the arrival of the lost
signal before transmitting more data. In this case, data transmission resumes when
the remote end of the connection receives the next XON signal.
Modem
Connection Time
Sets the number of seconds to wait for data mode and clear to send and receiver
ready signals after asserting request to send and terminal ready signals.
Default: 60
Options
0, 1, 5, 10, 15, 20, 25, 30, 60, 120, 255
Note: The router waits forever for the modem to connect when the parameter
setting is 0 (zero).
Modem
Disconnection Time
Sets the wait period, in seconds, for the Console port after the modem disconnects
and before the modem reconnects.
Global and Session
Parameters
1
Global and Session Parameters
Parameters and Options
1-7