Filter
Top Products
When the global Auto Enable is set to Yes, the IPX router (as are all other
application software modules) is conditionally enabled—the IPX router can be
enabled or disabled by setting the IPX-specific Auto Enable parameter.
Default: Yes
No
Disables the IPX router. You will need to re-enable the IPX router manually with
the NCL Interpreter after the node boots.
Yes
Enables the IPX router.
Circuit Group
Identifies the circuit group providing a connection between the node and IPX
network.
Deliver NETBIOS
Bcasts to net
Enables or disables remote access to “local” servers.
Default: Yes
No
Disables broadcasting and effectively isolates local NETBIOS servers from remote
clients.
Yes
Enables the delivery of received NETBIOS broadcasts across the local interface,
thus making local NETBIOS servers available to remote users.
Dest Host (high)
Sets the upper boundary of the range for filtering an IPX packet based on the
contents of its destination host field.
Options
Leave this field blank if you do not want to filter IPX destination hosts.
Leave this field blank and enter the IPX host number in the Dest Host (low) field
if you are filtering a single IPX destination host.
Enter the highest IPX host number in the range if you are filtering a range of IPX
destination hosts.
Leave this field blank and enter the name of the Host list in the Dest Host (low)
field if you want to use a Host list to establish the upper and lower range of IPX
destination host numbers.
For additional information, refer to “Dest Host (low)” later in this chapter. For
more information about Host lists, refer to “Host Number (high)” and “Host
Number (low)” later in this chapter.
Dest Host (low)
Sets the lower boundary of the range for filtering an IPX packet based on the
contents of its destination host field.
IPX Protocol Parameters
Parameters and Options
11-6