Filter
Top Products
Note: All routers on the OSPF backbone must be configured with the same values for
Hello Interval and Dead Interval.
Default Route Listen
Determines whether the IP router adds network and subnet default route
information, received in RIP updates from neighboring routers, to its internal routing
table.
Default: No
No
Prevents the router from adding received default route information to its internal
routing table.
Yes
Allows the router to add received default route information to its internal routing
table.
Note: For Default Route Listen to be enabled, RIP Listen must be set to Yes.
Default Route Supply
Determines whether the IP router advertises default routes in RIP updates sent to
neighboring routers.
Default: No
No
Prevents the router from advertising network or subnet default routes.
Yes
Allows the router to advertise default routes.
Note: For Default Route Supply to be enabled, RIP Supply must be set to Yes.
Dest IP Address
Accepts the IP destination address used by the relay agent written in dotted-decimal
notation.
DLCI
Specifies the Frame Relay Data Link Connection Identifier to the target host.
Drop If Next
Hop is Down
Determines the disposition of a filtered datagram if the next hop is unreachable.
Default: No
No
Allows IP to consult its routing table and provide an alternate route for the datagram.
Yes
Drops the datagram
Effect
Determines whether a packet is dropped or relayed (filtered) based on the contents
of a packet field and a range established by a matching set of (low) and (high)
parameters. The packet field and corresponding (low) and (high) parameters are
listed in the following table:
Internet Protocol (IP) Parameters
Parameters and Options
7-10