Filter
Top Products
Note: To use the 32-bit encapsulation scheme, all interfaces on the network must
have sufficient memory resources to handle 32-bit encapsulation. An interface with
sufficient memory resources to handle 32-bit encapsulation can unpack packets with
16-bit and 32-bit encapsulation. An interface that supports only 16-bit encapsulation
cannot unpack 32-bit encapsulated packets.
General multicast
DLCI
Refer to ‘‘Multicast Support’’ on page 4-22.
Group Address
Accepts the broadcast address for an SMDS circuit.
Heartbeat Down Count
Sets the number of unacknowledged heartbeat polling messages to be consecutively
counted before declaring the SMDS circuit down due to lack of communication with
the DSU.
Default: 6 (messages)
Note: If DXI version 2.1 is selected (Use DXI v3.2 set to No), this parameter is
ignored.
Heartbeat Polling
Interval
Sets the number of seconds to wait between sending heartbeat poll messages to the
DSU.
Default: 10
Individual Address
Specifies the 10-digit SMDS address. SMDS addresses mirror the North American
Plan (NANP).
Intervals Between Full
Polls
Specifies the interval between Full Status Inquiry messages transmitted by the
router to the Frame Relay network. The Full Status Inquiry messages requests the
Frame Relay network to respond with a Full Status Report listing all PVCs, the PVC
state (active or inactive), and whether the PVC is new or previously established.
Default: 6
Note: The default response (6) configures the multiprotocol router to send a Full
Status Inquiry message every 6 polling intervals; that is, if the polling interval is 10,
the router sends a Full Status Inquiry every 60 seconds.
IP Address
Specifies the 32-bit Internet address of the Point-to-Point circuit. Enter the IP
address in dotted-decimal notation.
LAN Address
Changes the station address (also called the physical or Ethernet or MAC address)
for the port assigned to the circuit.
Circuit
Parameters
4
Circuit Parameters
Parameters and Options
4-15