Filter
Top Products
Cfg: cannot get zone name list for
ccg
Meaning: This message is generated only if the circuit group specified by
ccg
is a
nonseed port. After a nonseed port obtains the default zone name from
a seed router, it issues a query to obtain a list of zone names associated
with the network. This message is generated if the port fails to receive a
response to its query.
Action: No action is required. The nonseed port repeats its query until it obtains
the list of associated zone names.
Cfg: dflt zone name must be cfg’d for
ccg
Meaning: The circuit group specified by ccg has been configured as a seed port.
No response was entered, however, to the Default Zone Name parameter.
Action: Configure the Default Zone Name parameter for the circuit group.
Cfg: Illegal construction in Zone name
Meaning: The zone name has a bad \xx hex construction. An ‘‘illegal default
zone...’’ event or an ‘‘illegal zone name...’’ event will follow in the Event
Log to show the invalid zone name.
Action: Use Quick Configuration or the Configuration Editor to correct the zone
name.
Cfg: illegal zone name
zone name
Meaning: The zone name that you entered uses an incorrect format of the escaped
character syntax. A non-hexadecimal, non-backslash (\) character was
entered as one of the two characters immediately following a backslash
(\) character.
Action: Configure a valid zone name to replace
zone name
.
Cfg: invld dflt zone name for
ccg
Meaning: The circuit group specified by ccg has been configured as a seed port.
The directly connected network is serviced also by another seed router
Event Log Messages
at: AppleTalk Event Messages
17-6