HP (Hewlett-Packard) 200 Network Router User Manual


 
The following paragraphs describe how to use the List command to step
through branches of the MIB, using the “buf” information base as an
example (see figure 16-2 above).
To begin with “buf” after displaying the objects shown in figure 16-3, you
would enter at the NCL prompt:
list buf
or
list 11 Note in figure 16- 3 that 11is the object identification code
for buffers. It can be substituted for the name ‘‘buf’’.
In response, the console displays formatted data like the following:
[1] map=0002code=1
(There is only a single branch descending from “buf”).
To see branches descending from “[1]”, you would enter:
list buf[1]
or
list 11.1 (from the code shown in the last response)
In response, the console displays formatted data like the following:
msg map=0002code=0
pkt map=0002code= 1
To see branches descending from “pkt”, you would enter:
list buf[1].pkt
or
list 11.1.1
In response, the console displays formatted data like the following:
init map=0004code=1
free map=0004code=2
min map=0004code=3
miss map=0004code=4
size map=0004code=5
corrupted map=0004code=6
NCL
Commands
16
Using the Network Control Language
Accessing the Management Information Base
16-37