Filter
Top Products
Parameters and Options
Circuit Group Name
Accepts a maximum of 12 alphanumeric characters to identify the circuit group.
ETHER1G
The default when configuring an Ethernet LAN port.
WAN1G
The default when configuring a WAN port.
Circuit Group Speed
Used for WAN ports to enable the setting of the MIB interface (‘‘if’’) Speed entry in
the ‘‘if’’ table by providing this value in response to SNMP “gets” requesting the ‘‘if’’
speed setting.
Default: 56000
Circuit Name
Identifies the circuit for the associated connector. The default startup and default
Quick Configuration set this parameter to the name of the Connector. This name
should also appear on your network map. In HP Series 200 and 400 routers, the
default circuit name includes the circuit type and related port number (1 -- 4). For
example:
ETHER1 The first 802.3/Ethernet port configured
WAN2 The second WAN port configured
In HP Series 600 routers, the default circuit name also includes the number of the
slot in which the associated port is installed. For example:
ETHER21 The first 802.3/Ethernet port in the second slot
WAN32: The second WAN port in the third slot
Note: You can change a circuit name to nearly any character sequence you want, but
it is recommended that you use names that identify the associated slot (if any) and
port numbers for each circuit.
Circuit Group
Parameters
5
Circuit Group Parameters
Parameters and Options
5-3