Filter
Top Products
No
Disables source routing over token ring media.
Yes
Enables source routing over token ring media.
Note: If the router does not have a token ring port, always set this parameter to No.
Source Host (high)
Sets the upper boundary of the range for filtering an XNS packet based on the
contents of its source host field.
Options
Leave this field blank if you do not want to filter XNS source hosts.
Leave this field blank and enter the XNS host number in the Source Host (low)
field if you are filtering a single XNS source host.
Enter the highest XNS host number in the range if you are filtering a range of XNS
source hosts.
Leave this field blank and enter the name of the Host list in the Source Host (low)
field if you want to use a Host list to establish the upper and lower range of XNS
source host numbers.
For additional information, refer to “Source Host (low)” later in this chapter. For
more information about Host lists, refer to “Host (high)” and “Host (low)” later in
this chapter.
Source Host (low)
Sets the lower boundary of the range for filtering an XNS packet based on the
contents of its source host field.
Options
Leave this field blank if you do not want to filter XNS source hosts.
Enter the XNS host number in this field and leave the Dest Host (high) field blank
if you are filtering a single XNS source host.
Enter the lowest XNS host number in this field and enter the highest host number
in the Source Host (high) field if you are filtering a range of XNS destination hosts.
Enter the Host list name in this field and leave the Source Host (high) field blank if
you want to use a Host list to establish the upper and lower range of source host
numbers.
For additional information, refer to “Source Host (high)” earlier in this chapter. For
more information about Host lists, refer to “Host (high)” and “Host (low)” later in
this chapter.
Source Network (high)
Sets the upper boundary of the range for filtering an XNS packet based on the
contents of its source network field.
Xerox Network Systems (XNS) Router Parameters
Parameters and Options
10-12